Thymosin Alpha-1 / 10 mg

Reconstitution & Dosage Guide

Reconstitution Steps

Draw 1.0 ml bacteriostatic water with a sterile syringe.
Wipe top of Peptide and Bacteriostactic Water with alcohol to disinfect.
Inject slowly down the vial wall; avoid foaming. All our vials are vacuum sealed, so when inserting syringe to add bacterioststic water hold plunger so it does not shoot the water into the peptide or vial.
Gently swirl/roll until dissolved (do not shake).
Refrigerate at 2–8 °C (35.6–46.4 °F)

Thymosin Alpha-1 (10mg) Dosage Guide

Maintenance Dosage (1.5mg): Draw to the 15-unit mark.
Ideal for: General immune maintenance and seasonal wellness.
The Sweet Spot (3mg): Draw to the 30-unit mark.
Ideal for: Standard protocol for active recovery or chronic inflammatory support.
Advanced “Blast” Dosage (5mg): Draw to the 50-unit mark.
Ideal for: Intensive immune support during periods of extreme stress or travel.

Protocol & Cycle Length

Frequency: Administer twice a week (e.g., Monday and Thursday).
Cycle Length: Typically run for 4 to 6 weeks.
Expert Tip: Tα1 is best used in “cycles” to reset immune function rather than as a permanent daily supplement.

Administration Tips

Injection Site Sensitivity: Because Thymosin Alpha-1 is an active immune signal, you may notice a small, itchy red bump at the injection site.
Expert Tip: This is a localized immune activation, not an allergy. To minimize this, let the syringe reach room temperature for 5 minutes before injecting and rotate your sites (abdomen, thighs, glutes) regularly.

Vial of Metabolic Peptides Thymosin Alpha 10mg with red cap.