Glutathione / 1500 mg

1. Remove the vial from freezer storage (−20 °C / −4 °F) and allow to equilibrate at room temperature for 15–20 minutes.
2. Draw 10 mL Bacteriostatic water with a sterile syringe. All our vials are vacuum sealed, so when inserting syringe to add bacterioststic water hold plunger so it does not shoot the water into the peptide or vial.
3. Inject slowly down the vial wall; avoid foaming.
4. Gently swirl/roll until dissolved—solution should be clear (do not shake).
5. Label and refrigerate at 2–8 °C (35.6–46.4 °F).

After reconstituting this 1500mg vial with 10ml of Bacteriostatic Water, use the following marks. Also remember start with a low dose and titrate up slowly as tolerated. (Low & Slow)

• Low Dosage (150mg): Draw to the 94-units (94ml) mark.
  Ideal for: General antioxidant support and daily immune maintenance.
• The Sweet Spot (300mg): Draw 188-units (188ml total in two 100ml syringes)
• Ideal for: Liver detoxification, athletic recovery, and noticeable skin-brightening effects.
• High Dosage (450mg – 600mg): Requires 281ml to 375ml.
  Ideal for: Intensive detox protocols or advanced recovery. Large volumes should be split into multiple injection sites.

Glutathione works best when levels are built up and then maintained.

• Frequency: Administer 2 to 3 times per week.
• Cycle Length: A typical cycle lasts 8 to 12 weeks. This timeframe allows the cellular “trash” to be cleared and the skin/liver to show visible improvements.
• The Break: Take a 4-week break after your cycle to allow your body to maintain its own endogenous glutathione production.

• Go Slow: Glutathione is a larger volume injection (0.5ml to 1ml). Inject slowly to minimize any temporary “fullness” or stinging at the site.
• Subcutaneous vs. IM: While it can be done subcutaneous (into fat), many prefer shallow Intramuscular (IM) injection (like the shoulder or glute) for larger doses like 300mg to improve absorption and reduce site irritation.
• The “Sulfur” Smell: Don’t be alarmed—Glutathione is a sulfur-containing molecule. It is normal for the powder or the reconstituted solution to have a slight “rotten egg” or metallic scent.

Important: This guide is for educational purposes only and is not medical advice. For research use only. Not for human consumption.