Kisspeptin / 10mg

1. Remove the vial from freezer storage (−20 °C / −4 °F) and allow to equilibrate at room temperature for 15–20 minutes.
2. Draw 3.0 ml bacteriostatic water with a sterile syringe. All our vials are vacuum sealed, so when inserting syringe to add bacterioststic water hold plunger so it does not shoot the water into the peptide or vial.
3. Inject slowly down the vial wall; avoid foaming.
4. Gently swirl/roll until dissolved—solution should be clear (do not shake).
5. Label and refrigerate at 2–8 °C (35.6–46.4 °F).

Kisspeptin is typically taken once daily, with consistent timing being more important than the exact hour of administration. Evening or nighttime dosing is often preferred, as it aligns with the body’s natural hormonal signaling rhythms and supports more physiologic downstream hormone release.

After reconstituting this 10mg vial with 3ml of Bacteriostatic Water, the concentration is 3.33mg/ml. Using this dilution, use the following marks on a standard U-100 insulin syringe:

• Low Dosage (100mcg): Draw to the 3-unit mark.
  Ideal for: Maintaining baseline hormonal signaling during a research cycle.
• The Ideal Spot (200mcg): Draw to the 6-unit mark.
  Ideal for: Stimulating natural testosterone and LH production.
• High Dosage (500mcg): Draw to the 15-unit mark.
  Ideal for: Intensive “Axis Reboot” protocols and fertility research.

In men, the primary goal is usually restoring natural testosterone production or maintaining testicular function during a research phase.

• Cycle Length: 10 to 14 days of continuous use.
• The Break: Follow with a minimum 14-day break.
• Frequency: Usually administered once daily (at night) or twice daily (morning and night).
• Maintenance Option: If using it for long-term support rather than a “reboot,” it can be used 2–3 times per week (e.g., Mon/Wed/Fri) for up to 8 weeks, followed by a 4-week break.

In women, the cycle is typically shorter and more specifically timed to align with the natural menstrual cycle.

• Cycle Length: 5 to 10 days.
• Timing: In fertility research, it is most often used during the follicular phase (the first half of the cycle, starting around Day 3 or 5) to help trigger the LH surge required for ovulation.
• The Break: Usually discontinued after ovulation occurs, with a break lasting until the next cycle begins.
• The “Restart” Protocol: If the goal is to restart a missing period, it may be used for 10 days on followed by 20 days off until the cycle returns.

Important: This guide is for educational purposes only and is not medical advice. For research use only. Not for human consumption.